Accessories Kit for Shark IQ R101AE (RV1001AE) IQ R101 (RV1001) Robot Vacuum Cleaner Replacement Parts Pack of Main Brush, Filters, Side Brushes

This refill hardware for the Shark robot is great. The only complaint is the bottom roller. The original bottom roller brush scoops are made from silicone, this one is some kind of harder material and is extremely NOISY. It woks fine, just be ready for that loud sound.

This kit had 2 filters I could use and the twisting up front brushes the rest in this kit do not work with my shark 1010AE the roller brush makes my vacuum stop every couple seconds and tell me to clear debris from under it

Works, the brush wheel has clothe glued to the rubber fin and is unraveling. The round filter is too short. I cut a piece of original. The rest work great. Not bad for cost honestly I think 30 buck little less.

Everything in the package is correct. The roller brush does not work properly. When it gets on carpet it will stop the vacuum cause the brush gets stuck. The little strips on the brush are too long.

The one that comes with my vacuum is 4 inches and yours is only 2 1/2 inches. So I feel cheated.

All the filters work but the main spinning one underneath! Keeps sending off error messages because it doesn’t spin! im going to have to have to order off shark site.

I ordered this because Shark parts were too expensive and out of stock. I did however order a round filter from Shark and was surprised to find that they sent the same 2 tall filter included in this kit. Why they dont have the original filter I dont know but I ordered the one for my unit and it was the small one. Everything else fit fine and does the job. Some people have said the roller was causing errors but I havent had that problem. It does however collect more stuff around the roller. Not a big deal though.

I was able to use everything in this kit on our robot except the roller brush. As another commenter stated, the rubber pads/brushes are too long (could be the angle its cut I dont know) I set it in the robot and day one it refused to run, until I swapped back to the original. Trial and error, Its still worth the money imho for the filter replacements. Me being the terrible owner that never cleaned the base filter.

The large filter did not fit but everything else was fine.

The replacement beater started to drag within two months. The vacuum would not work anymore. Bad quality!