COMOWARE Hole Saw Kit for Wood- 16 Pieces 3/4’’-5’’ Full Set in Case with 1pcs Hex Key, 2pcs Mandrels and 1pcs Install Plate for PVC Board Plastic Plate Drilling Drywall and Soft Wood

This isnt great. It got the job done but with a lot more effort that it should have. The teeth arent very sharp and several pieces dont fit properly together

I purchased to cut a 5 in hole in a soffit. 3/4” thick. If u start too slow all the teeth will catch. Maybe enough to break the tool? I don’t know but i started to slow and the teeth caught and instantly stopped the drill. So i started with a faster rpm and was able to cut all the way without catching or stopping. Worked for what i needed it for.

i bought the set to make holes in 3/8 plywood for my greenhouse .about 400 holes cut with the 3 inch bit and its still quite serviceable. great value for the price , am very pleased.

They are cheap and won’t hardly go thru wood

Purchased this for only one reason: to cut 2 cornhole holes. Product came in 2 boxes. 1 for the holesaw and the other for the arbor bit. Added bonus, the drill bit portion was protected by a spring. Easy to assemble. Inserted it into my drills chuck (3/8), tightened it and started cutting. I proceeded slowly because I wanted a clean cut. It cut easily through the 1/2 plywood. I cannot speak to overall durability or ability to handle thicker wood. Yes, I recommend this product for similar jobs.

Used this to go through asphalt shingles in the roof to put in a vent. If I had more than a couple to do, there would have been a problem as the tool was chewed up. For softer plywood, the quality would be fine.

The only thing that was missing was the standard diameters. Close size is good enough for most jobs.

A necessity for drilling holes for water supply/drain pipes for a new bathroom vanity that had a solid plywood back. I was skeptical right at the beginning of the first drill when I smelled essence of pine from the plywood, but slow, steady pressure saw the job through. Even when I moved from the back to the front side where there was a nice, finished veneer surface, the drill cut through with perfect holes with a fine finished look. The only drawback was that no instructions were included with the package, and being a novice woodworker, I managed to get the job done without destroying the finished surface of the vanity, (Thats the only reason I gave it 4 stars.)

I shouldn’t be surprised considering how cheap this is. Even so it baffles me a little how quickly it tore up and broke from regular use. The FIRST time I used it. The pilot hole bit snapped in half and the center piece that fits in the drill chuck broke. The blades seem fine. So I’m just going to replace the center bit and keep rolling.

Not a good buy for any practical utility. May be ok for thin plastic. The drill bit had trouble getting through a 1.5 inch pine board. I used a 7/32 drill bit to pre drill. The 1+1/2 inch hole blade wasnt very sharp. The saw dust wasnt being ejected out, despite pulling it out every 1/8 inch or so. I ran my drill at half speed and paused every 30 seconds (hoping not to build up too much heat). I thought maybe I wasnt spinning fast enough to get the sawdust out of the teeth so I speed it up. The wood started smoking (of course) so I stopped. When I ran the drill in reverse (slowly) to pull out the hole saw, the drill bit broke (see pictures). Also, the depth of the saw is a hair shy of an inch (so getting through a 2x4 takes two passes). Just thought Id iterate that here because it didnt help my frustration (I fully take responsibility) . Reading it and experiencing it are two different things.