E3D Genuine Heater Cartridge - 24v 40w (E-HEATER-24V-40W)

I updated my hot end from 12v to 24v and this has been running strong.

The quality of construction looks superb. The problem is the photo in the listing does not match what is shipping. The wires are white, BUT, it does not have the right angle feed into the cartridge, and more importantly, it does not have the plug as shown to detach quickly when swapping a hotend.

Needed to replace the heater cartridge on my Prusa MK3S. Arrived next day and works perfectly!

I chose an authorized reseller for this item. Mine was the white one and it works great on my Prusa MK3S+. The cable on this is a little longer than the original but its not bad.

Well it looks nothing like the picture.... it works but we’ll see how effectively. Basically a scam.

Does the job. Replaced my old one on a Prusa i3 MK3S that got ruined by a blob incident. The wires I got are white.

Used on my Prusa Mk3S Same temperature curve.

This works well in my Prusa i3 MK3S. Theres not much more to say than that. It replaced the one that my printer came with after I broke the connection to the old one when trying to hot tighten my nozzle. One thing to note is that I was sent a white one, not a red one as shown. I dont know if the items description says colors may vary, or not. And, really, how much of the cable do I see? And, really, do I even care? Also, Ive noticed that the hot end tends to shoot past the target temp by about 2-3 degrees C before settling back down. I dont remember if the old one did that, so Im just assuming it did, and that this one is no different.

As described

I made sure I bought from the vendor others recommended to get a legit one. Works well when I needed to replace my heater cartridge on my MK3s. Would buy again if I need a replacement.