MG Chemicals - 4885-227G 4885 63/37 Rosin Core Leaded Solder, 0.032 Diameter, 1/2 lbs Spool

I normally use 60/40 ratio A friend turned me on to this 63/37 leaded and to my surprise It actually was for the the better It made quicker bonds less heat to the flight controllers I was soldering on. It felt all round better so its now my solder of choice hope this helps someone Great product!

Excellent works great

Has been great for my solding of small wire, electronics and a r/c micro drone. Would buy again

Get this if you want shiny solder joints! Only choice to make is what gauge - I prefer 22ga for fine works. Sn63/Pb37 is eutectic meaning it melts/solidifies at a single temp making it easy to solder your component and it stays in place as soon as you take away the soldering iron. Been using this for 20 years. Good stuff!

I wanted a good quality solder that I could use for hand soldering fine components. This solder is perfect for that and it wasnt ridiculously expensive like some solder at retail stores.

My goto solder for my mini quad builds and repairs.

Good wetting, flows nicely and leaves a very shiny surface. Its RA flux so it should be cleaned afterwards but datasheet does say it can be left on the board. I tried a lot of solder as a hobbyist and this stuff wins best bang for buck easily.

Nice flow, no issues, not a single complaint I can think of.

As described

good stuff