MICROJIG Matchfit MB-025-0514 Dovetail 1/4 Shank 14° X 1/2 Router Bit,

Works great. Make sure the depth is correct. Cut to shallow and the clamp protrudes above the groove

Good durable, but expensive. Bought these with Micro Jig DVC-538K2 MATCHFIT Dovetail Clamps to use on miter saw table I built. The bit started to slide out while is use causing cut to go deeper. But slots still work. It would be nice if included with clamps at least option, which are also expensive.

Best dovetail bit out there for making the match fit stuff. This special bit has an upper rounded edge that truly cuts down your time on sanding afterwards! If your using it for matchfit hardware then buy this bit. Its worth it!

This bit makes the perfect groove for the dovetail clamps, with nice rounded edges. I didnt need to sand them at all. Ive seen Youtubers who have made the grooves using a standard dovetail bit and they end up with sharp, torn-out edges that require tedious sanding. For me it was worth the money to avoid that. To extend the life of this bit, I do make a straight groove with another bit first to remove most of the material.

On the first use one of the cutters came off in the middle of a 15 inch dado.

Used to make a tapering jig along with the microjig dovetail clamps. Works great and creates a tight fit.

Does a much better job cutting the grove for the 45 degree clamps I have.

My second bit. The first one had a thicker shank for my table router. This one fits my dewalt hand router. Made more tracks already with this bit.

Made a work table using this bit and many other woodworking jigs. It’s so versatile!!!!

Product worked as expected