PGN UCP205-16 Pillow Block Bearing - Pack of 2 Mounted Pillow Block Bearings - Chrome Steel Bearings with 1 Bore - Self Alignment

:)

I had to tap the bearings with a hammer to make them straight but otherwise good

3 of the 4 bearings I ordered were pressed in crooked by 15-20 percent. Terrible to allow these out unchecked. Have returned for refund and will never purchase from you again. One out of 4 I could understand (just) but 3 unusable out of 4...thats never acceptable!

Looks nice

installed works well

Im using these bearings for a steering Colum, I understand this is an odd use case but while adjusting the angle of the bearing they fell out of the housing a lot of times. This caused me to have to weld up some weird angled brackets to make sure the bearing dont just fall out and loosen my steering shaft at 50 MPH. Figured this might be helpful for someone, good product otherwise.

Excellent heavy built product.

The ISO 9001-2008 died a few years ago. If you didn’t receive the 2015 rating, then you failed ISO requirements and can no longer say you are ISO certified. Who writes these things for these products?

They worked

Although seemingly well built and turns smoothly, the inner diameter of the bore is slightly less than 1. My calipers read closer to 0.967. Fortunately I had access to a bench grinder and was able to reduce the outer diameter of my 1.054 pipe in order to get a better fit.