Premium 3D Print Removal Tool Kit - Durable 3D Printer Tools with Sturdy Comfort Grips, Sharp and Hardened Blades for Easy Separation of Prints, Knife and Spatula Set of 2 - Enhanced Version

These are quality made. The smaller one works so good. Ive used both several times now and are awesome. I use a glass plate and I apply glue stick. PLA or ABS comes off like a charm with these. They are strong and stiffer flex which helps prying a little.

The long blade is my personal favorite and has performed flawlessly for the removal of my large prints. The smaller tool is OK and will do in a pinch, but it goes mostly unused as I print a lot of larger objects. I just purchased another set, so I can have one by each of my 3D printers. The long blade has worked especially well in hard to remove prints. As some others have mentioned both blades have round ends on them and are tapered to a thin (pretty sharp) edge, this helps enormously when youre trying to get a bite under the stuck print, it also helps to prevent damage to your print bed surface. These two removal tools are a great value and work much better than hard/stiff square edged putty knives!

Easy to use and takes prints of glass bed extremely easily.

Fantastic, sturdy, very well built tool. The knife edges were perfectly machined, making your job so much easier.

These removal tools exceed my expectations. They require substantially less force to slide in under the prints, then the removal tool that came with my printers.

Very well made. Easy to use. Just was I needed for my 3d printer. Also fast shipping.

Works really well. Tossed them on an order just to try out and will buy again if I need to. Works better than the razor scrapers you can print off, and doesnt damage the bed.

I got mine not sure if it’s a lemon but I didn’t bother sending it back since I was able to polish most of it out but as you can see on the pics the larger tool has gouges on it even after it getting polished, after getting cleaned it was able to get prints off the buildplate the smaller tool was quite handy too after getting cleaned since the working end had some dings on it and it was getting caught on the edges again after some Sanding and polishing it works. Check photos for the gouges but last photo shows the polished tip

Great product, packaged well. Much better than the cheapo unit I was using from a local craft store.

I like the long spatula. Flexibility is about right. The blade is sharp. It does a good job of getting under the part on the print bed. As for the shorter spatula, I like the offset blade as it gives a different angle of approach. And its stiffer than the long spatula which could come in handy. However, the front edge is blunt, which makes it un-useful for removing 3d prints. Fortunately, it was easy to put an edge on it using my Dremel with a grinder tool. But I would rather have a factory sharp edge instead of having to DIY one myself.