sisona 1/8 3/16 1/4 5/16 3/8 Carbide End Mills Set - Solid Carbide (Tungsten Carbide + Cobalt) - 5Pcs 4 Fulte CNC Mill Bits for Steel - TISIN Coated

My wife ordered this for me through Amazon vine, so this is her husband leaving the review. Good quality carbide for the price. From my typical suppliers, these would have cost a lot more.

At this point, Ive really only tested the 3/16 bit. Material removes cleanly, chips consistently. The first few cuts with this bit have been clean and crisp. The bit shows no wear, but for carbide, it really hasnt been tested hard yet. Reasonable price point, based on the anticipated bit life. As time progresses, Ill report on durability...

They look very good

Awesome! Great Buy.... Very happy

Works great

I would call these a good value for money. They showed great durability in a 1952 Bridgeport mill cutting 304 stainless steel.... and I cut a lot of it on a single cutter. Good job, I will buy more.

These have been working well for a home gamer like me. I dont use them a lot, but have not had any problems and they do a great job.

These Sisona bits do cut through thick solid steel pipe and thick ceramic AFTER using a different kind of drill bit to start the hole. You CANNOT use a center punch or anything on ceramic though. And a center punch isnt going to go far in the solid steel pipe I tried to drill through. HERE’S WHAT HAPPENED IN THE STEEL PIPE I got two sets of Stubby Drill Bits for Thick Steel at the same time. The largest NordWolf Bit wasn’t big enough, but it did easily stay centered on a Very Thick, Very Heavy Steel Pipe, and drilled through the first side like hardwood. Then I was going to try the same size bit in this set on the other side and it absolutely would NOT stay, no matter what I did. No matter how strongly I held it or careful I was, it kept walking and wandering off to the side. I tried a lot of times, and it would Not even START to drill a hole. I really wish I could have actually got a hole drilled with one of these bits, because the NordWolf only stayed sharp for the one side. It went completely dull on the very next side. Didn’t even drill two holes. HERES WHAT HAPPENED IN THE BOTTOM OF THE LARGE CERAMIC POTS Two large Ceramic Pots outside needed holes in the bottom before it rained. Again, the NordWolf drill bit was too dull after one use to even start the hole, so I used the next size down. And again, these bits absolutely wandered and walked away constantly, even from the starter holes I made!! I finally finished, but my cordless drill worked harder than ever before. I hope its OK.

I get it these are specialized tools. Not everyone has a milling machine. Well, I know someone that does and I have some parts that will need milling. Since I know I want him to do it as a friend, I figured this would be a nice trade. These are Tungsten Carbide and cobalt. We will be cutting a steel hitch that is 2.5” and needs to be milled to 2.0”. While we have not used them yet I am told that this is a good set and exactly what is needed to do the job. As far as price goes, I am no expert on these. I see prices for way less to way more. Once I see them cut the value will be in did they work as expected. When I have time to go over and he has time to mill, I will update my review. For now, not having much to go on except my friend the expert’s word I think this is a good set and recommend them.

Super hard and strong. Drilled through angle iron without any problems. Nice durable set.