SpeTool Extra Long Spiral Router Bit Down Cut 1/8 inch Cutting Diameter, 1/4 inch Shank 3 inch OVL HRC55 Solid Carbide End Mill for Wood Cut Carving Engrave

Cuts nice and clean

The bit snapped after routing out a few butterfly joints. Lasted less than an hour of use.

I was using this for the first time and the bit broke on me within a minute of use

Great

I use these a lot. They work great but with a long small diameter cutter like this it is not too difficult to break them. These are great quality and value.

I needed a long 1/8 end mill so I bought this one. It broke on the first pass. My depth setting was .o4.

Broke almost immediately and was cutting with its set specs listed...so so disappointing..

Broke on the third pass on the MDF my students were cutting.

Really like the length and reach however cutting even at slow feeds and shallow doc seemed to much. But just seems dull compared to other brands I’ve used.

The end mill has a great price point and high quality.