Thermalright Intel 12th/13th Generation LGA1700 Anti-Bending Buckle,CPU Stress Bending Correction Fixer, Curved Pressure Plate,Fully Fitted and Fixed Without Trace Installation (Black)

As per gamers nexus and jays two cents, this provided a better pressure distribution on my cpu. Low profile and more reliable than the stock bracket

Fácil instalación (tienes que ser extremadamente cuidadoso) se instaló con un procesador y motherboard nuevo, ayudó bastante en las temperaturas

This is my first build in 4.5 years, so this time around I wanted to do tons of research. Im installing a CPU water cooler for the first time ever and researching that a fair amount led me to these CPU brackets. Ive never been satisfied with the cheezy, light weight CPU brackets/fasteners which come standad on MBs. This seemed like a valuable asset for just $14. Im running a 13th Gen Intel on an MSI Z690 ACE MB. As you can see from the pic, the fit looks very clean and the aluminum bracket is well machined. I do not know if temps will be lowered vs the stock guillotine bracket but it sure holds the Intel in place far better. And that can only be good.

Literally dropped temps by 20c just by adding this to my i5 12600k.

I tried this modification because I didnt like how much torque was being applied to my CPU when using the stock fastener. I am not sure if it was actually bending the chip but it was under too much pressure in my opinion. Temps improved slightly. Easy to remove original and install and looks cleaner than original silver clamp. Comes with tool to remove and reinstall screws.

When I bought my i7-13700K, the CPU would randomly spike to 100 °C while idle and stay at that temperature for 4 to 5 minutes. I upgraded my CPU cooler to a corsair 420 mm CPU watercooler, but the same issue occurred, although it didnt stay as long at 100 °C. The problem disappeared when I switched to the Thermalright contact frame. I also noticed an improvement in the average temperature of the CPU at idle and under load. It is clear that this contact frame helps the CPU behave in a better way, especially for a CPU that is known to overheat.

Luckily I stumbled upon a video from Gamers Nexus highlighting these. Bought one because why not. Easy to install and it feels like my cooler is more secure than ever. I am running a z790 board with an Intel 13700k. My temps havent even needed to kick the fans on full blast yet.

Installed this on my Asus Maximus Z790 Hero with no problems. Used factory screws from motherboard and no issues. Make sure to tighten in criss cross pattern to make sure it tightens evenly and doesn’t bend. Highly recommend as this also lowered my CPU temps on my 13900k

I have to say that this new approach to CPU retention has been an amazing surprise. After reading reviews from some well-recognized testing & bench-marking experts, I decided to give it a try. Installation following the online video was simple. After installing the CPU cooler and running it under monitoring software at high-demand usage for several hours, I noticed a real drop in CPU temps!! I am sold!

No instructions. Luckily I found a youtube video