Thermaltake V-Tubler PETG Tube 16mm (5/8) OD 1000mm 4-pack
-
Kevin L. Greer
> 3 dayPersonally I’ve seen clearer tubes. Had a few lines in it here and there. Size was good. No trouble sealing or bending.
-
Gutib luke
> 3 dayGreat product
-
M. Fell
> 3 dayGood quality PETG tubing.
-
Matt Harper
> 3 dayWorked out great, and price was more reasonable than some other brands that were available and half the tubing. Pipe was very easy to bend, as long as you dont use a too high temp you are fine. You are able to reheat a tube if it did not turn out right, but you have to be careful as you can warp your bend even more.
-
mjplatt
> 3 dayEach individual tube is in an individual plastic sleeve to prevent scratches. If you dont have one, order a heat gun as well to make the custom bends unless you are going to buy a lot of fittings. It takes practice to get the bends correct and you will have a lot of scrap, so order more than you will need.
-
Vsevolod Braila
Greater than one weekWorks as intended
-
CM
Greater than one weekThey are some of the most competitively priced tubes you can find. I finished a entire build and still had half leftover.
-
Anon
Greater than one weekPETG bends really easy and nicely and this is no exception. Only thing I will cation is when using this with EKWB parts the fitment is TIGHT on the o-rings. Even when using pipe cutters that dont leave burrs, the tubes still needed sanding cause they would cut the o-rings.
-
HighVAC
> 3 dayGreat to work with and softens at a decently low temperature.
-
Valerie Bryant
20-12-2024Scratched and dinged, but fully functional.
