Timber Wolf Bandsaw Blade 1/2 x 93-1/2, 4 TPI

These are well built. Wish I had bought these from beginning. Havent used it atot so cant speak on longevity, but sure it will last.

I had a fairly new blade that would not cut, perhaps I dulled it slicing a frozen turkey. I put this blade on and all my problems with were solved. It tracks straight and it cuts with little resistance a little expensive but it works well

Only had blade for one day,but it is of good quality

I set it up as instructed. It cuts extremely well. It cuts clean with very fine tooth marks and narrow kerf. I like the low tension required for this blade. I know it cost more but it should last much longer. I resharpen my other blades two or three times and if I can do so with this blade I will more than get my moneys worth.

Wow... these blades are amazing. Ive used bosch blades for years, never expecting there ro be much difference between plain steel blades... but these are no pin steel blades. They cut very fast with much lower tension and follow a line much better than the other blades Ive used. If your thinking of trying out these blades to see if there is a difference ... dont wait. Buy them now. If you dont , when you finally get around to it, youll wonder why youve suffered with subpar blades when these are readily available. They make my Harbor Freight 14 inch saw cut like a champ.

After receiving a Vermont American 31345 1/2-Inch by 4TPI by 93-1/2-Inch Stationary Fast Wood Cutting Band Saw Blade and installing it on my newly re-tired Delta band saw, I found it would not even begin to cut a block of 2 x 2 white oak, So, I read more reviews and bought this Timber Wolf blade which came with some very exacting instructions. I followed them while installing it, tuned the saw as they suggested, and introduced that same piece of white oak to it. The Timber Wolf cut it like it was butter!! What a relief and what a great blade!

I am a woods teacher and we have several hardwood projects this shop runs 7 hours a day. this blade can take a beating. I tried the carbide infused, carbide blades 2 weeks then dull/ this blade is the forst blade that the shop has had that stays sharp over a month. first rate all the way

Purchased quite a while ago and did not want to review until I put it to use. Value was very good. The item came with easy to follow directions and care. Put it on my saw and did not take it off from the day it arrived. I have not needed to sharpen it or remove it from the saw. I am very happy with this product. So I believe it was on the saw about 6 months straight. Yesterday it cracked and today I am looking to see if I can weld it back together.

New bandsaw owner (used Jet 14”) and after reading online about the highest quality blades I decided to go ahead and spend the extra money on the Timber Wolf. I had alread upgraded my saw with the Rockler 10 bearing guide kit but the blade that came with the saw still wandered all over the place and took way too much pressure to cut even soft wood. It felt sharp to me but I knew it needed replacing. Well once I installed and tuned the new 1/2” Timber Wolf blade, I marked a straight square line across scrap wood and cut it using the miter gauge. It tracked the line perfectly and went through it like I was cutting air. Spend the extra cash, you won’t be disappointed. I did not give a stat on longevity as I haven’t had it very long but will come back and revise this review once I’ve put some use into it.

This blade has made a huge difference on my Delta 14” bandsaw. My unit has only 1/2hp motor which can barely run a high tensions resaw band. With this low tension design the saw is running better than ever now that it doesn’t have to fight so hard just to idle.