Whiteside Router Bits 3000 Template Bit with Ball Bearing

Nice router bit and cuts well but the set screw comes loose and falls out and by the time you realize its missing its hard to find in the waste on the floor, if it hasnt been flung off to the far reaches of the workshop.

This bit was perfect. If you need to do perfect mortises off of a template this is what you need. I had another bit just like this one made buy one of the big companies that always made a mortise in need of fine tuning, this one was perfect from the start. Thanks to Stumpy Nubs for turning me on to this company. I will be sending them more business.

I purchased this bit to route (28) 2 diameter X 3/16 deep holes in oak. The bit worked fine for the first 10 holes. Then it began to wear. It became difficult to push thru the wood and started to burn the wood. It took several hours of tedious sanding to remove the burn marks. The reason I gave it two stars instead of one is that the bit cut well at first and did a good job of removing chips into my vacuum attachment. By the way, I let the bit cool for 5 minutes after every 4 holes.

Needed to inset a router plate in the router table top I am making. And yet again I need a new tool, be cheaper to just buy a router table but hey the tool will come in handy sooner or later. Nice clean cut with smooth bottom, fit of the router plate matches fit in the template. I made it a tight fit expecting the cut would be a fraction wide. Nope its not, oh well it will wear in with some time. Not worth sanding out.

Whiteside is my go-to for specialty router bits. Quality is always superb, and price is comparable to many inferior products.

Its nice to have a small pattern bit available, lets you take smaller bites at a time.

Cuts nice. Bearing is smooth. Bearing same size as cutter so I could use with pattern to cut out latch mortises. Still sharp after a couple dozen doors. Expect it to last years.

I purchased the same bit at three different cut depth: Whiteside model #3000, #3001 and #3004. Be aware they are not for heavy work like (typically found at) Carpentry but they have place for furniture and cabinet making. I love to have all of them as it is easy to work with quite similar bits with interchanged bearings. I just work with the smaller of them, the #3000 model and as expected it performed spotless even for very heavy ipe wood. I expect the other two bits are at the same quality level. Strongly recommended.

I paid more for this single bit than I did for a whole set of cheapo imported bits. However, I use this bit a lot, and its a joy. The cheap bits are only used occasionally, so I dont have elevated expectations for them. They do work, however. This bit is beautiful to look at, and very satisfying to use. No chattering, and cuts wood like its butter.

Good quality bit. I needed to swap out the bit on my Ryobi hinge jig and this bit has performed better that the original. I have done 20+ doors and bit is still sharp.