Wolfride Rabbet Router Bit Bearings Replacement Bearings for Router Bits | Inner Dia. 3/16” & Outer Dia. 3/8, 1/2, 5/8, 3/4, 7/8, 1, 1-1/8

first use I failed to provide a backer board when routing a small rabbet in a thin piece of plywood and the bit gauged too deep when the bearing flexed slightly... MY BAD!!! great selection of sizes, lots of attachment screws, good accessory for my router

This set of Wolfride Rabbet Router Bit Bearings worked perfectly for us. The set allowed us to utilize several of our previous owned standard router bits in more effective and efficient ways which ends up saving money from purchasing more single use bits.

Used bearings in the construction of mower blade balancer. Worked well for the project.

Bearing came apart with in 39 seconds of first use, can trust others in set.

I mounted this horizontally on some shelving next to my bench grinder. I just drilled a hole slightly smaller than the shaft and then hammered it in. I use it to balance lawn mower blades while sharpening them. It just happens to have a bearing that fits the center hole on my Craftsman lawnmower perfectly. I trust this way more than those cheap balancers that have the blade rest flat on top of it. Those you have to eye ball level. Theyre probably good enough, but this thing doesnt leave much room for error. Either it rotates left or right and needs more metal removed, or it doesnt rotate and its balanced. I got the idea from seeing those ridiculously expensive wall mounted balancers and then going on youtube to see if there was a DIY version. Sure enough, some guy had a video using this item. Im sure you could fabricate some sort of magnet to keep the blade from falling off like the expensive ones, but Ive never had my blade fall off. The bearings are wide enough that the entire width of the blade is in contact with it. I only put it up there for a couple seconds, take it off and grind and then re-check until it doesnt move. The blade is never left there where it could be accidentally bumped off, I dont have anything I care about under it and I keep my hands close so i can grab it in the center, if for some reason it did pop off. Those magnets are pretty cool though. ;) Hope that helps you.

The internal and outside dimension are as advertised The bearing is somewhat loose and moves slightly in an out and side to side not anything significant that would make it functionally substandard. Overall a good purchase for the money paid and will work for the intended purpose. One wish is if they could include spacing washers. Those are hard to find and if a washer is damaged it needs a replacement together with the bearing.

I need it these for some of my router bits. Fits good.

Helped me get through a project. These bearings are not all the same brand. It is a mix of brands. Some of them were decent quality, and some of them were not that great. Would give it a 3.5 star if I could.

I am happy with this product. It is nice to have spare guide bearings for guided router bits. They dont last forever and keeping a stock is handy.

Bought these last week for a special project I have going along with some bits. Less than six inches of work and the bearing I was using from the set flew apart. Happened to have the same size on an old bit I have and used it instead. Trimmed 40 feet of facia board without further trouble. Id give them no stars but looks like I might have to give them one. Am sure disappointed with the Wolfride bearings and am returning them for something else!