ABN Hollow Punch Kit Leather Punches Tools Hole Punch Set Gasket Punch Set Gasket Cutter 3/16 to 1-3/8in (5-35mm)

I have already used these a good number of times and they look like they did new still. They cut clean round holes in gasket material. These are just what I had been looking for.

Easy to use cuts perfect holes

Great for punching gasket material.

The quality of these cutting tool are great. Upon arrival you will notice that every piece of hole punch has a burr or the inside along the edge. To remove the burr, I just used a rolled 1000 grit sand paper and used it as a strop to remove the burr edges, Just make sure to only sand away from the burr edge to pull the burr piece back up again or snap off. Once the burr is removed from every hole punch, you will be able to make sharp hole punches if you use the correct bottom plastic punch board and a solid base. If you don’t have a solid bottom heavy base, your hole punches may not get the correct pressure needed for a nice hole punch. I used this punch set to cut into 1/8 thick cowhide leather to make perfect sized holes. I pitched a plastic bottom punch board which feel like a plastic cutting board. For my solid base, I used a 25 all steel weight lighting plate and hit my leather with the plastic.punch board between them. It works flawlessly and the edges stay sharp longer if you remove the burr before using. Takes less than 1/2 hour to de-burr the whole set. I used a cheap rubber mallet with a wooden handle to hit the back of the punch tool. No damages done to the tool and the rubber mallet works perfectly. I rate this product as 5 Stars for quality and value, All it takes is a little de-burring and you set for a long while before sharpening.

it works good,wish there was one size larger,but its still good overall

Differents size to use in my job and home

Poor quality ,mala calidad ...mala mala ,no lo recomiendo

I used these to punch through upholstered thin plywood. I liked the way the punch assembled and the punch part was easy to clean out. They did a fine job.

The punch set works great for making gaskets. The set made very nice holes on gasket material. I will be using it often.

After the first use they are dull and wont even cut anymore