EPAX nFEP Film Sheet 200 x 140mm Thickness 0.125mm for E6/X1 and Other 5.5/6 inch UV Resin 3D Printers, Pack of 3 Films

Seems like less pulling force than FEP.

I was super excited to get a Sonic Mini 4K printer, but then incredibly disappointed by failed print after failed print which wasted many hours of my life. I sanded the build plate with 80 grit sandpaper each time and cleaned and lubricated the NEP film each time, but still the prints failed to stick to the build plate and stuck to the NEP instead. Only after increasing the exposure time way up did prints stick to the build plate. But of course then the prints were overcured and the detail destroyed. I finally gave up and tried this Epax NFEP film and, bingo! Successful prints the first try. Recommend. I ordered the 3 pack and I did receive 3 pieces.

film seems really good but my package came practically bent in half bending the films

Great solution for my Phrozen Mini. Easy to install and trim with a sharp knife.

Ive tried a few other brands, but the EPAX nFEP sheets still work the best for their machines. They are solid & clear, and I can get months of printing with them before theres any real fading or issues. One of these packs would last me a year - if I were less accident prone

Used on a Voxelab proxima 6 4k. Releases perfectly. I dont hear the usual drum sound when the bed pulls away from the nfep. Was a bit of a pain to punch holes in it but I had a punch to accommodate the two sizes of holes. Seems worth the cost and trouble.

I tried this out on my Elegoo Mars and so far its ok. Im not wowed or astonished. It does the job. But I think Im still replacing it at about the same rate I was replacing regular FEP. Maybe my printers not high def enough or etc to show a difference, but with an Elegoo Mars, using Elegoo ABS-Like resin, so far its all the same.

I have had nothing but headaches from this product. I was getting respectable success before trying this stuff. A weeks worth of failed prints trying to get this nfep to work. I tried calibrating every variable I could, heated my enclosure, re leveled the bed with different paper thicknesses, slower lift speed, longer exposures. A failed print from this film broke one of my lcds. This film seems to make light pollution worse, and seems to make an even worse popping sound from the normal elagoo brand fep. I have two longer orange 30s, if any printing wizards out there have any advice for me I would really like to get some of the results other people are talking about. But so far this stuff has set me back.

Love it thanks

This stuff works so much better than the regular fep sheets. Since having installed this I have not have a failed print due to it sticking to the fep, my fails are completely my fault now. Lol.