Sackorange 608 ZZ Skateboard Bearings, Double Shielded,8x22x7 Miniature Ball Bearings（Pack of 20)

I bought these to use for some 3D prints. They are skateboard bearings, so they come pre-greased. I would have preferred to have non-greased bearings, but it makes sense that they would be greased.

The dimensions are WAY off. Pressing these in was more like dropping a toothpick into a volcano. Luckily i dont need a press fit for my application, so it didnt matter. You really get what you pay for here. Also the race was PACKED with FOD. So much aluminum or steel glitter is packed in with the bearings, it feels like sand when you move the bearing around. Only two out of the pack where smooth. This is real bottom of the barrel stuff, but its also literally the cheapest i could find. Im pretty sure the oil that was covering them was some kind of caustic nonsense and it made my skin red where it touched me.

Kind of trash and hardly worked. Almost all failed with a roll pin installed.

Filled with some of the cheapest thickest grease they could get. Takes a ton of effort to get these spinning smooth. Cleaned out the grease with brake cleaner, and used an oil meant for ball bearings and they spin much better now, but nowhere near high quality bearings.

Got these for 3d print use, some are definitely smoother than others but for what i needed them for, perfectly fine. If using for a skateboard etc, might wanna seek something of better quality unless money is super tight

VERY Noisy and Rough. I seriously question the ABEC-7 rating. I got these because they were low cost, and you get what you pay for. As other reviewers noted, they come in plastic tubes of 10, and are coated in sticky grease. I wiped them clean, flushed them thoroughly with PB Blaster, 3-in-1 oil, air tool oil, WD-40.... they spin freely but feel very rough and are noisy. Rolling them in my fingers I can feel the roughness and I even go so far to say that it feels like there is dirt inside, they catch occasionally and are that rough. These will probably be a good solution for slow speed applications where noise and smoothness is not a concern. For smoother, higher speed operation, and quietness, Im going to spend a few more $ next time. I have the same size bearings from another manufacturer which were a higher cost, but there is a night and day difference in quality. Ill be saving these for something unimportant and testing purposes only. Nothing I build can accept this poor of quality for more than a brief period.

I used this product for a wind spinner and it works better than ever. I also have several spares if needed. It saved my wind spinner from being trashed and I was so happy!

I ordered these to use as bearings for fidget spinners, I know. These were nice and cheap, and I wanted to give these a go. When they arrived, I noticed a couple had small spots of rust on the inside, so I emailed the company and they replaced them no questions asked and were very responsive and helpful. After decided the rust wasnt really that noticeable, I popped off both shields and then let them soak in gas so it would break loose all the grease (wasnt much). After letting them soak and shaking it a little, I took them out and let them dry. Afterwards, I sprayed them down with RemOil and took them inside. In a pretty light spinner, theyll spin for about a minute! I prefer these over the Bones Reds, simply because they spin longer and theyre cheaper. Overall, great product for the price and great customer service!

I bought these to replace old bearings in my bandsaw guides. They work fine, though I did have one in the package with substandard machining and you could feel friction when spinning it. I tossed that one and the rest were good.

I am not using them as they are intended to be used. I am over speeding the bearings. But they are holding up