TEMO Carbide Downcut Inlay Router Bit 1/32 Inch Diameter

Arrived the day after I ordered. The set of bits is exactly what I needed.

Excellent bit, been using it with my x-carve for multiple engravings and they all come out crisp and clean. I accidentally plunged the Z-axis in too deep and had thought it wouldve snapped but surprisingly it didnt. Im writing this review for that reason alone as I was pretty much prepared to purchase another bit but like i said, the bit did not break.

Working as expected

TEMO is our go-to when we need to purchase more CNC bits. They last a long time (as long as you dont screw up and break them, user error!) They are delivered quick. I purchase their 1/8, 1/16 and 1/32.

Junky bit. Get what you paid for, I guess.

I use these bits on an X-Carve. The’ve been more durable than the 1/32 bits from Inventables.

I ordered three of these bits given their price and that I mill a lot of items so its understandable I can go through them quickly. Unfortunately, I feel I broke a record by breaking all 3 within 24 hours of them being delivered. 2 broke almost immediately during milling jobs while one was able to actually complete a job, but it eventually broke immediately on the following job. I am cutting exotic wood species and actually had success with these very same bits and had one that lasted me for about half a year. I am very careful with my equipment and I tend to configure jobs to run at a more cautious level, but even those parameters are too intense for these week bits. These are the most unreliable mills I have ever used. I will be demanding a refund for these weak, faulty products. Do not order these!

These are great bits. Just remember the rules of routing with fine bits. 1. Never cut deeper then the diameter of the cutter. The cutter not the shaft. 2. Dont move faster then the cutter can cut. If you violate these rules then fine detail bits of any brand will break.

I purchased two of these bits and both of them broke just after a couple of uses.

This is my favorite bit. I use it on my CNC to cut small stuff with a great amount of detail with minimal sanding. These don’t break unless I do something dumb, like dropping them or forgetting to switch the router on...