Vilros Raspberry Pi 4 & 400 Compatible Power Supply (USB-C) with on/Off Switch

works, not much else to say

The product works like a charm. It provides enough power for the Pi 4, and the on/off switch is a plus.

Like the switch

This makes turning the Pi on and off way easier than plugging and unplugging it.

it works

No instructions so here is the important thing. Do not put the brass standoffs into the case first. First take the 4 brass standoffs with the hex on one end and the threaded rod and put the threaded shaft portion up from the bottom of the PI board out the top side. Then screw the knurled nuts on from the topside. Then place the board into the case, may have to tilt it side ways to get it in but it will go, then screw the small flathead screws in from the bottom of the outside of the case. In a regular computer motherboard the standoffs screw into the case first but this is opposite. Also there is no instruction about where to put the heatsinks so Google it, it is pretty obvious anyway.

Great Purchace. Very well made

This charger does exactly what I wanted it to - provide a convenient on/off switch to control the power supply for a Pi 4. Ive used it for several hours of uptime (and through a couple of power cycles) now without any adverse issues. I personally find it really helpful for dealing with a Pi that will not be always on - so I do plan on shutting it down and cutting off power from it. This charger helps me do that without having disconnect and reconnect the Pi after a shutdown to bring it back up again.

I keep getting a low voltage warning and to check my power supply. :(

Powers the new Raspberry Pi 4. The On/Off switch is a much nicer solution then removing the USB-C connector.