Yonico 13168 3/4-Inch Radius Round Over Edge Forming Router Bit 1/2-Inch Shank

I bought these Yonico router bits due to their quality for price. High grade finish and build. It did not burn the wood and leaves a clean, crisp and smooth cut.

The bits come in a beautiful sturdy wood box. The carbide is very high quality and brazing is very clean on each bit of my set. The non-stick yellow coating is applied clean and even. The bearings are high quality and bolt down well and secure on to the shaft of the bits. The name on the shaft is put on neatly on each bit of the set. There was also an surprise coupon in the packaging for future purchases!. Bits run very well on the router and perform very well hand held or on the table. I have routed many feet of MDF, plywood and soft woods like pine. The bits route clean and there is no strain on the router, I feel that I was able to route my stock a lot quicker than with my lonely old round over bit this set replaced. I had only one scrap of poplar to try for hardwood and it did just fine. Tips: 1) as soon you receive the bits inspect them. 2) be very careful removing them from the box as the carbide will cut your fingers and you see it before you feel it. 3) inspect and clean the bits to remove the manufacturing sticky stuff. 4) The carbide edges on the smallest three bits can touch at their widest point when inserting in the box. Take care to stagger the edges so they dont touch. Update: I had an issue with one bearing and emailed customer support. I got a response in a couple of hours and they only asked for a picture of the errant bearing and mailed out a new one the same day. Thats good customer service. The feel good part of this event is that in the initial response, Jonathan the CSR advised that all the bits of the set have the same size bearing and I can swap them to finish my project in time. Saved my weekend. Thats thoughtful customer service. To watch the this brands bits in action view the review by WoodWorkWeb on youtube.

Really good for the price. I make my own mouldings, but Im not a professional. This is the right balance of quality and value. I buy Yonico bits almost exclusively - just works out that they have what I need... good but cheap.

Excellent! Equal to many big name router bits, with a price lower than most!

I replaced all of my deck railing caps using 2 X 6s, but I wanted nice rounded edges on the top. This was my first time using a router so I wasnt sure exactly what I was in for. I borrowed my neighbors because I dont own one. I watched a few videos first and read all of the information. First I tried his 1/2 roundover bit, but it didnt produce enough of a radius for my liking, so I purchased the 3/4. I am so pleased with the way it turned out. The edges are smooth and consistent throughout. Using a palm sander afterwards made it look even better. I did not experience any problems at all with the bit. There was a total of about 80 linear feet of 2 X 6 caps that were all being rounded over on both edges. The bit was still just as sharp at the end of the project as it was at the beginning. Couldnt ask for more.

Very sharp giving a smooth cut. Seems to be beefier than other bits I have used.

Bits work perfect for our current project

i just tried this on my router table, and made some 3/4 quarter round. worked great.

Wood working

looks good and cuts clean, good value for the money